Dutch version
 
 


 




When a company operates on the boundaries of the µ-area it is a must to have suitable means to control. The central measuring room is equipped with several high-end measuring devices amongst others a Perthometer (contour meter including roughness meter) from Mahr and a roundness meter. One of the masterpieces is the ‘DeMeet 400’ an optical/mechanical tester for executing 3D measurements in a fully automatic and computer controlled way.

The basis for the top in accuracy and product quality lays in the workshop. In terms of accuracy the machinery fitting the products are no less than the measuring devices, Normex believes this is the best guarantee for an optimal result. Besides this the operators on the machines can use the built-in measurement devices during the process that can measure up to ±0,3µm, this way our committed employees can safeguard and when necessary adjust during the process.

The by Normex BV supplied goods can, if the customer wishes so, be delivered with a full measurement rapport ensuring the quality of the delivered goods. An added bonus is that during any contingent disaster/failure the cause is fast and easily to be found.

 

Measuring procedures always are adapted conform to the customers demands. When working with tolerances of as small as ±1 µm it is of extreme importance to know that products are measured the same way in the same conditions to exclude any misapprehensions.

The by Normex BV supplied goods can, if the customer wishes so, be delivered with a full measurement rapport ensuring the quality of the delivered goods. An added bonus is that during any contingent disaster/failure the cause is fast and easily to be found.

Measuring procedures always are adapted conform to the customers demands. When working with tolerances of as small as ±1 µm it is of extreme importance to know that products are measured the same way in the same conditions to exclude any misapprehensions.


View a short 'Control measurement' movie

 
Machineries
To suffice the special demands in accuracy and product size Normex is proud owner of adequate machineries. Besides capabilities such as flat-smoothening.
 
Product showcase
To demonstrate the Normex knowledge, capabilities and operating level here are several illustrations of products that are produced by Normex FMI.
 



Normex is a registrated trademark.

Copyright © Normex Fijn Mechanische Industrie B.V. | Normex Medical B.V.